How To Slow Down Electric Meter

(Alert!!!! Doing the electrical meter "hacking" methods stated herein is PUNISHABLE nether existing laws.)

Tampering the electrical meter is not new or at least in our lifetime we heard it once. There are many ways to hack or tamper our meter in order to get a cut on our electricity nib. Just most if non all forms of tampering the electrical meter are considered illegal. Thus, tampering our electrical meter is punishable nether RA 7832 (RA 7832 Anti-Electricity Pilferage Act of 1994) which provides for both fine and imprisonment up to 20 years.

The various ways of electricity theft ranges from actual tampering of the electric meter to using devices that electronically or electrically slows downwards or even stops the meter. The following "hacking" methods are the most commonly-known but prohibited nether Philippine Law.

USING A MAGNET

The electric meter is an electro-mechanical consecration device. It uses electricity (consumes about two watts to operate itself), moving parts (similar the aluminum dial), and an electromagnetic (induction) motor. The electric meter uses eddy current to regulate the rotation of the punch in accordance with the actual consumption of electricity.

Hence the meter uses electromagnetism (consecration) it is also possible to interfere its move by using magnets. The magnets of considerable sizes should be placed straight at the sides of the meter.

BORED HOLE & NEEDLE

This method involves directly tampering by boring hole or holes anywhere in the meter's plastic casing. The tiny pigsty is then inserted with a needle which volition stop or slows down the spinning aluminum dial. This tampering method tin be easily spotted by the meter readers of the ability company.

SALT & SUGAR

Salt can enhance the electrical conductivity of h2o while sugar isn't. Run into demo virtually information technology. Simply the properties of salt and sugar have cypher to practice about tampering electric meter. Table salt and sugar are placed or sideslip through the slit of the electric meter to distract the spinning dial. Worst, ants volition swamp inside the meter for the thirst of sugar.

BREAKING THE SEAL

If putting a magnet and filling in table salt & sugar on your electric meter is non enough, a breaking in is possible by cutting or removing the seal that locks the meter from tampering. This will pb to the next method– using a jumper.

JUMPING ALL THE Way TO VECO

Using a jumper to skip the electric meter is an onetime-fashioned tampering method but it's the easiest. It's done by disconnecting the line after the meter and instead connect it direct to the service line of VECO (Visayan Electric Company). This tampering method is easily detected past government.

TURNING THE METER UPSIDE, DOWN

If enough of the same is non enough, then turning your meter upside down could be a way to cease the meter. Simply this is very obvious and volition be brusque-lived considering the visitor'southward meter reader shall telephone call the maintenance to set up information technology.

The meter can be stopped from running or even reverse its move to reduce the bodily consumption reading. This can exist done past using the and so-called CURRENT REVERSING TRANSFORMER which are sold in the form of a ability-saving device. Some of a bulb has virtually no result on the electrical meter. Somewhere inside that seedling possibly a electric current reversing transformer.

Source: https://onlineweirdstories.blogspot.com/2013/10/hacking-your-analog-electric-meter-to.html